Keri Systems LC-208 Wiegand Elevator Control - Manual (Page 10)

Wiegand Elevator Control Panel
1530 Old Oakland Road, Suite 100 01879-002 Rev. C
San Jose, CA 95112 USA
(800) 260-5265 (408) 451-2520 FAX (408) 441-0309
Web: http://www.kerisys.com E-mail: [email protected]
Page 10 of 24
Quick Start Guide
LC-202W/LC-208W
5.1 Connecting Wires - Removing Terminal Blocks
Follow the instructions in Figure 4 when connecting wires to the controller or when removing
terminal blocks from the controller.
Figure 4: Connecting Wires and Removing Terminal Blocks
5.2 LC-202W Wiring Connections
The following connections are made to install the LS-202W Elevator Control panel (see Figure 3 on
page 9).
• Floor Control Relay via W-TB-A
• RS-485 Controller Network via W-TB-B (network out) and W-TB-C (network in)
• Reader/Amplifier Daisy-Chain via TB-B (reader output) and W-TB-C (reader input)
• Earth Ground and Power via TB-C
5.2.1 Floor Control Relay
The Floor Control Relay is connected to the door controls at the elevator panel. If a controller has
an SB-200 Satellite Board attached to control two floors, connect the lower floor to the A-Floor
Control Relay and connect the higher floor to the B-Floor Control Relay. Make the floor control
relay connections per the information in Table 1 and Figure 5 on page 11.
Table 1: Floor Control Relay
Connection
LC-200W TB-3 Pin
SB-200 TB-7 Pin
Description
1 Normally-Open
2 Common
3 Normally-Closed