Kenton LD2Pro - Manual (Page 3)

3
CHANGING THE NUMERIC DISPLAY MODE
To change the display mode to 0-20 or back to 0-127, hold the learn button in for a few seconds. At first it
will display L r n (learn), but after several seconds it will show 20 for 0-20 mode or 127 for 0-127 mode. If
you continue to hold the button in, it will continue to toggle between the two modes. When the mode you
want to use is displayed, release the button and the unit will be ready to use again. This setting is also
stored in the non-volatile memory. If you learn program change, then display mode will be reset to 0-127.
LIST OF CONTROLLER NUMBERS
Controller Number Control Function
0 Bank select MSB
1 Modulation wheel or lever
2 Breath controller
3 Undefined
4 Foot controller
5 Portamento time
6 Data entry MSB
7 Main volume
8 Balance
9 Undefined
10 Pan
11 Expression controller
12 Effect control 1
13 Effect control 2
14-15 Undefined
16-19 General purpose controllers (1-4)
20-31 Undefined
32-63 LSB for controllers 0-31
64 Damper pedal (sustain) (Hold 1)
65 Portamento on/off
66 Sostenuto
67 Soft pedal
68 Legato footswitch (val 0-63=normal 64-127=legato)
69 Hold 2
70 Sound controller 1 (default=sound variation)
71 Sound controller 2 (default=timbre/harmonic content)
72 Sound controller 3 (default=release time)
73 Sound controller 4 (default=attack time)
74 Sound controller 5 (default=brightness)
75-79 Sound controllers 6-10 (no defaults)
80-83 General purpose controllers (5-8)
84 Portamento control
85-90 Undefined
91 Effects 1 depth (formerly external effects depth)
92 Effects 2 depth (formerly tremolo depth)
93 Effects 3 depth (formerly chorus depth)
94 Effects 4 depth (formerly celeste (detune) depth)
95 Effects 5 depth (formerly phaser depth)
96 Data increment
97 Data decrement
98 Non-registered parameter number LSB
99 Non-registered parameter number MSB
100 Registered parameter number LSB
101 Registered parameter number MSB
102-119 Undefined
121-127 Reserved for channel mode messages