Kenton Modular Solo - Manual (Page 14)

14
P 93 Prog receive enable - (default: Off)
- Sets the function of the MIDI Out socket. The following can be selected:
MIDI Out/Thru [MO]
Sync 24
[Syn]
P 98 Load Prog
- Sets the number of the program to be loaded as the current setup .
Range 1 to 32
To load the selected program, press and hold the SELECT button until LoD appears in the display.
P 99 Store Prog
- Sets the number of the program into which the current setup will be stored.
Range 1 to 32
To store to the selected program, press and hold the SELECT button until Sto appears in the display.
The MODULAR SOLO will always respond to controller #64 (sustain pedal)
You can use program changes to load programs from memory if enabled in parameter 93
To get the parameter name to scroll across the display, press the SELECT button twice.
Leave parameter 32 (LFO MIDI sync) set to OFF unless you are actually using it.
If you have stopped a sequence and are left with a hanging note, you can turn it off by holding the SEL
button for about 6 seconds until the display shows noF (note off) except while parameters 98 or 99 are
selected (in which case the long hold executes load or store).
If you wish to reset your MODULAR SOLO, you can do so by turning the power on whilst holding down
all three push buttons. This will return the MODULAR SOLO to it’s default settings. ‘Fd’ (factory
defaults) will momentarily be displayed when this has been done.
There are two jumpers for linking CV & Gate to the bus situated behind the power/bus connector. Both
jumpers are set to off at manufacture. A jumper always links 2 out of the 3 pins, so the centre pin is
always used. When a jumper links the two pins nearest the bottom edge of the PCB then it is
connected to the bus. CV is the jumper nearest the bottom edge of the PCB. Gate is the other.
The power connector is wired in the standard way with the –12v pins nearest the edge of the PC board.
The bottom is the edge of the PC board
OTHER USEFUL INFO
RESETTING THE MODULAR SOLO TO FACTORY DEFAULTS
DIRECTING CV & GATE OUTPUTS TO THE BUS
INFORMATION ABOUT THE POWER CONNECTOR