Vermont Casting 6000 - Manual (Page 11)

Tools Needed:
3/8”
wrench
7/16”
wrench
1.
2.
3.
4.
5.
11
Assembly Step 2 - Attach the Base to the Pillar
Lock the pre-assembled casters on base by
pushing down on the latch.
Set the pillar upside down.
Set the base upside down onto the pillar
bottom as shown, aligning the holes in the
base with holes in the pillar.
Insert the four bolts through the holes in the
pillar and base. Thread the locking hex nuts
onto bolts. Tighten the bolts and nuts with the
wrenches.
Carefully turn the assembly upright onto the
casters.
USE HARDWARE BAG A :
LOCATE THESE PARTS:
1/4-20 x 3/4”
bolt (4)
base assembly (1)
1/4-20 hex
nut (4)
locking
caster
back side of pillar,
upside down
locking
casters
back side of base,
upside down
pillar
assembly (1)