Chicago Electric 90715 - Manual (Page 14)

Page 14 SKU 90715
Bobbin Winding
1. Change the Clutch Release Switch (10) from the needle mark to the bobbin mark.
2. With a spool of thread already on the horizontal spool pin, route the thread through the
guide to the bobbin as shown below.
3. Place the bobbin onto the bobbin winder shaft (B) and slide the shaft to the right. Turn
the bobbin clockwise until the spring (C) on the shaft slides into the slit on the bobbin.
4. Hold the end of the thread from the bobbin and gently press the Foot Controller (13) to
begin winding thread around the bobbin a few times as shown below. Release the
Foot Controller.
5. Trim the excess thread above the bobbin and continue winding the thread onto the
bobbin. The machine will automatically stop when the bobbin is full.
6. Cut the thread, push the bobbin winder shaft to the left, and remove the full bobbin
from the shaft.
7. Return the Clutch Release Switch (10) back to the needle mark.
Slide to right