Chicago Electric Electric Impact Wrench 68099 - Manual (Page 9)

Page 9 For technical questions, please call 1-800-444-3353. Item 68099
SAFET
y
Op
ERA
TION
M
AINTENANCE
SETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION yy section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-
lit. The work area must not allow access by
children or pets to prevent distraction and injury.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
General Operating Instructions
The Impact Wrench is equipped with a rocker-type
Trigger that can switch between clockwise (forward)
rotation to counterclockwise (reverse) rotation.
1. Press the desired Socket (sold
separately) onto the Anvil.
2. Plug the Power Cord into a
120V~ / 60Hz grounded outlet.
3. Press the LOWER part of the Trigger for clockwise
(FORWARD) rotation or the UPPER part of the
Trigger for counterclockwise (REVERSE) rotation.
Note: The Trigger will not activate if both settings are The Trigger will not activate if both settings are
pressed down at the same time.
CAUTION! To prevent injury: Use both hands to operate
the Impact Wrench, keeping one hand on the Handle
and the other hand on the Housing. Do not hold or touch
impact sockets during use.
4. When finished, release the Trigger.
Note: The amount of actual torque may vary
depending on the condition of the threads and
other factors. If tightening critical components,
check the actual torque applied to the fastener with
a mechanical torque wrench (not supplied).
5. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.