Crate Amplifiers CHANNEL GUITAR AMPLIFIER WITH ADVANCED DSP VTX65 - Manual (Page 9)

9
Using the Footswitch for More Presets:
The Crate three-button footswitch supplied with the VTX65 allows access to an addi-
tional DSP preset for each channel of the amplifier. When the footswitch is connected to
the amplifier as shown below, the “original” DSP presets are active for each channel
when the #3 footswitch LED is illuminated. These are referred to as “DSP Bank ‘A’.”
When the #3 button is switched and the LED is out, a second DSP preset may be stored
and recalled for each channel - “DSP Bank ‘B’.”
NOTE: DSP Bank “B” presets are only accessible when the footswitch is connected to the amplifier. When
the footswitch is not connected, only DSP Bank “A” is accessable.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operation.
"LEFT" jack "RIGHT" jack
Switch #1:
LED on = SOLO CH.
LED off = RHTYHM CH.
Only when Switch #2
is activated (LED lit)!
Switch #2:
LED on = SOLO/
RHYTHM CH.
LED off = CLEAN
CH.
Switch #3:
LED on = DSP
BANK "A"
LED off = DSP
BANK "B"
3 2 1
VTX65
Three-Channel Guitar Amplifier with Advanced DSP