Chauvet S-MOVER DMX512 - Manual (Page 13)

Master/Slave Mode (Master Sound, Master Auto):
This mode will allow you to link up to 32 units together without a controller.
1) Use standard DMX cables to daisy chain your units together via the DMX connector on the rear
of the units. For longer cable runs we suggest a terminator at the last fixture. For more
information about terminators, see page 8.
2) Choose a unit to function as the master. Press until ,
, or is displayed on the master unit.
3) Use the and buttons to scroll through until the desired mode is displayed and
press the button. is auto mode; is sound-active.
4) will be displayed when auto mode is selected; will be displayed
when sound-active mode is selected.
4) Press until , , or is displayed on
the slave units. Use the and buttons to scroll through until is
displayed and press the button.
5) will be displayed when slave mode is selected.
DMX Mode
This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with
DMX, please read the DMX Primer on page 15.
1) Press until is displayed.
2) Use the and buttons to select the desired address and press the
button.
DMX Channel Values
C HANNEL V ALUE F UNCTION
1 000 Ù 255 Pan: 128 = halfway point
2 000 Ù 255 Pan Fine
3 000 Ù 255 Tilt: 128 = halfway point
4 000 Ù 255 Tilt Fine
5 000 Ù 255 Vector Speed: (Normal > Slow)
6
000
Щ 007
008 Щ 023
024 Щ 238
239 Щ 255
Lamp On/Off & Strobe
Blackout
Open
Strobe: Slow > Fast
Open
7 000 Ù 255 Dimmer (100 – 0%)
8
000
Щ 250
251 Щ 255
Reset
No Function
Reset (after 10 seconds)
Stage Mover Manual 13 2007-04-13/09:39