Chatsworth Products RIM-600 - Manual (Page 26)

RIM-600 Manual
26
Enterprise Status
Unit
Type IP Status
RIM-600 Monitor Host 10.1.4.10 Ok
NY_Node Node 10.1.4.17 Ok
Press any key to return to main menu
Option 2 will display the network configuration for the Host as well as web server, RAS, and two-
way email settings. A sample of Option 2 is shown below:
Network and Option Configuration
Physical Address 00:D0:C9:37:40:86
IP Address 10.1.4.10
Subnet Mask 255.255.255.0
Default Gateway 10.1.4.1
DNS Server 10.1.2.111
Enterprise name RIM-600 Enterprise
Web Server Enabled
Web Server Security Enabled
Web Programming Option Enabled
Web Programming Security Enabled
Remote Access Server Enabled
RAS IP Port Address 0.0.0.0
Two-Way E-mail Responder Enabled
Microphone Listen-in Enabled
Datamodem Enabled
SNMP RO community public
SNMP RW community private
SNMP Agent Enabled
Allow remote configuration Disabled
Press any key to return to main menu
Option 3 will allow you to set all pertinent network settings listed under Option 2.
NOTE: You can remotely reconfigure the Host network settings using the RIM-600
ConsoleView software if the Allow Remote Configuration option is set to Y. However, the Host
must initially be configured via the serial port before any remote configuration is possible.
Option 4 allows you to configure or reconfigure the Enterprise name.
Option 5 allows you to configure the Web server. When Web security is enabled, a Profile
Username & Password must be entered to view the web page. A sample of the Web configuration
menu is shown below:
Configure Web Server
1. Enable Web Server: Y/N
2. Enable Web Status Security: Y/N
3. Enable Web Programming option: Y/N
4. Enable Web Programming Security: Y/N
26