Compaq Netelligent 1005 - Manual (Page 11)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8 Netelligent 1005 10Base-T Hub User Guide
Writer: Chris Seiter Project: Netelligent 1005 10Base-T Hub User Guide Comments:
File Name:1005.DOC Last Saved On:6/26/97 11:19 AM
EMI Warning
FCC Class B Certification
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following conditions:
Q This device may not cause harmful interference, and
Q This device must accept any interference received, including interference
that may cause undesired operation.
WARNING: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different
from the one which the receiver is connected to
• Consult the dealer or an experienced radio/TV technician for help
You are cautioned that changes or modifications not expressly approved by the
party responsible for compliance could void your authority to operate the
equipment.
You may use unshielded twisted-pair (UTP) for RJ-45 connections.