Jaypro Sports FP-90 - Manual (Page 3)

6) Remove excess water and any loose particles with a rag or other absorbent material.
Leave the hole clean and uniformly damp.
7) Mix the anchor bolt cement in a clean container.
Note: See manufacturers instructions for proper use.
Do not add sand, gravel, or other foreign substances to the cement. These weaken
the cement and affect the setting.
Do not add too much water or re-tempering cement, which has begun to set up in
the container, with no additional water. This will result in failure of the cement to
attain the proper strength.
8) Turn a ½” bolt into the floor plate enough to hold it securely. Pour the cement
mixture into the hole until it is about ¾ full. Dip the floor plate in water in order to
wet the outer surface, but do not let any water get inside. Holding the floor plate by
the top of the ½” bolt, slowly lower it into the hole until the top is level with the
surface of the floor. Excess cement should flow around the top. If not, more cement
should be added. Scrape the excess cement from around the floor plate with a putty
knife or scraper. Remove the ½” bolt.
9) Allow 24 hours from the time of installation for complete setting. After 24 hours,
apparatus may be set up and used with the floor plates.