Jaypro Sports FP-89 - Manual (Page 2)

JAYPRO SPORTS
FLOOR PLATE ASSEMBLY, FP-89
LIST OF MATERIALS
PIECE NO. PART NO. DESCRIPTION QTY.
1 FP891 Floor Plate Assembly 1
2 FP891A Flat Head Tapping Screw #14 x 2” 4
3 HS2726 Hex Head Bolt ½”-13 x 2 ½” 1
4 HN704 Hex Nut ½”-13 1
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED: Hammer Drill
1 3/8” Masonry Drill Bit
Mixing Container and Water
Small Vacuum Cleaner
Stiff Circular Brush (bottle brush)
Putty Knife or Scraper
Rag or Other Absorbent Material
Regular Power Drill
1 3/8” Wood Drill Bit
5/32” Drill Bit
Router
Screwdriver
with Wide Blade
½” Bolt
¾ lb. (Approx) Non Shrink Anchoring Cement
NOTICE
The FP-89 floor plate assembly is manufactured with a removable center section, which
can be replaced in the event that the internal threads are damaged. Upon original
installation of the floor plates or replacement of the threaded sections, be sure that the
replacement-threaded sections are installed very tightly using a thread-locking sealant to
prevent easy removal or tampering.
PLEASE READ INSTRUCTIONS IN THEIR ENTIRETY
BEFORE BEGINNING INSTALLATION
1) Locate and mark the center locations of the floor plates using the layout diagram
in the equipment instruction sheet. Re-check all center locations for accuracy
before installing the floor plates.
2) Using the 1 3/8” wood drill bit, drill a hole in the wood floor and the wood sub
floor down to the concrete base.
3) Drill a counter-bored hole 3 ¼” with a depth of ¼”. This may be done by using a
router and a template. A template can be made from a masonite or a thick piece
of plastic. Make a hole in the template material so that when the router is used
with it, the counter-bore diameter is 3 ¼”. Use a scrap board for practice and
checking the outcome of the hole before cutting the actual surface.