Jaypro Sports SEYL-824 User Manual
Page 3

Rev E, 07/09
JAYPRO SPORTS
SEYL-824, QUICK SET-UP SOCCER GOAL
IMPORTANT NOTICE:
1) BEFORE EACH USE CHECK EQUIPMENT FOR PROPER CONNECTING
HARDWARE AND STRUCTURAL INTEGRITY. REPLACE DAMAGED OR
MISSING HARDWARE IMMEDIATELY.
2) SECURELY ANCHOR (USING GROUND STAKES OR SAND BAGS)
MOVEABLE SOCCER GOALS AT ALL TIMES (ANCHORS PURCHASED
SEPARATELY).
3) NEVER ALLOW ANYONE TO CLIMB ON THE NET OR GOAL FRAME.
4) USE OF THIS EQUIPMENT OTHER THAN INTENDED, MAY BE
HAZARDOUS.
5) ALTERATION OR MODIFICATION OF THIS EQUIPMENT MAY BE
HAZARDOUS AND RESULT IN INJURY. FOR REPAIR OR
REPLACEMENT, CONTACT YOUR DEALER OR JAYPRO SPORTS.
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
(1) 9/16” Socket or Box Wrench
(1) 7/32 Allen Wrench
(1) Phillips Head Screwdriver
(1) Unpack all parts and check against parts list to ensure that all have been included.
(2) Inspect all parts for damage. Report any damages to the trucking company.
(3) Identify all frame components and lay them out on a flat dry surface. The goal should
be assembled face down.
(4) Assemble the top crossbar (items 6 and 7) as shown in (Detail D). Locate corner of
net and weave crossbar through leading edge (note: there is no specific top or bottom
to net as net is symmetric).
(5) Attach both left and right uprights (items 1 and 2) to each end of crossbar.
(6) Attach the lanyard plate of Quick Release Pin (item 9) to the back end of each base
frame (item 3), using the thread forming screws supplied (item 10). (Note: use
predrilled hole located in front of U-bracket - see Detail C)
(7) Attach the front end of base frame (item 3) to base of upright using hardware shown
in Detail B. (Note: front end of base frame has rounded corners). For best results lay
base frame overtop of upright.
For indoor use, apply adhesive backed rubber anti-skid pads to underside of
base frame – using scissors, cut pads in 3” lengths - four per side, equally spaced.
(See Detail E)