beautypg.com

Jaypro Sports STGRB824 User Manual

Page 2

background image

Rev-, 12/09

JAYPRO SPORTS

STGRB-824, 8’ x 24’ SOCCER TRAINING REBOUNDER


IMPORTANT NOTICE:

1) BEFORE EACH USE CHECK EQUIPMENT FOR PROPER CONNECTING

HARDWARE AND STRUCTURAL INTEGRITY. REPLACE DAMAGED OR
MISSING HARDWARE IMMEDIATELY.

2) USE OF THIS EQUIPMENT OTHER THAN INTENDED, MAY BE

HAZARDOUS.

3) ALTERATION OR MODIFICATION OF THIS EQUIPMENT MAY BE

HAZARDOUS AND RESULT IN INJURY. FOR REPAIR OR
REPLACEMENT, CONTACT YOUR DEALER OR JAYPRO SPORTS.


ASSEMBLY INSTRUCTIONS


TOOLS REQUIRED:

(1) 3/4" Socket Wrench and Box Wrench
(1) 5/16” Allen wrench


1) Unpack all parts and check against parts list to ensure that all have

been included.

2) Inspect all parts for damage. Report any damages to the trucking

company.

3) Assemble main frame (items 1, 2 and 3) on a flat dry surface, placing

uprights approximately 24 ft apart.

4) Slide one “T” fitting (10) onto the end of each upright (1), locating it

below the hole in the upright. Assemble the bottom crossbar (items 4
and 7) and insert into each “T” fitting. Tightening both setscrews in
each “T” fitting.

5) Thread ground stakes (11) into each base (5). Insert ground stakes into

the ground in the desired location – spaced at 24 ft apart. Sand bags
may be used in lieu of ground stakes if placed on turf (recommend two
50 lb bags on each end).

6) Using at least 2 people, lift the frame onto the vertical insert tube on

each ground base.

7) Assemble the mid anchor frame as shown in Detail C, and place it at

the center of the bottom crossbar – inserting the ground stakes into the
ground. If used on turf, place two 50 lb sand bags on the base leg to
prevent the bottom crossbar from bowing up when the net is installed.

8) Securely tighten the four setscrews in the “T” fittings to prevent the

bottom crossbar from sliding up when the net is installed.

9) Install the net by placing the bungees evenly around the perimeter.