Jaypro Sports WML-100 - Manual (Page 4)

to the front eyebolt on each frame hanger (2a & 2b). The chain assembly should
be straight but not taut.
4) Drive the end caps (item 11) into the open ladder ends and the small end plugs
(item 10) into the open ends of the frame hangers (2a & 2b) as shown. Carefully
slide the overhead ladder (1) onto the frame hanger such that it is equally centered
and resting on the angle brackets. Using a 1/8” drill bit, drill thru the holes in the
angle brackets into the bottom rail of the ladder and fasten in place using the #8 x
1” screws (item 15) provided.
5) Remove all slack on the anchor chains by tightening the turnbuckles. Using a
bubble level, insure the ladder is straight and level to the floor. Tighten all
hardware.
NOTE
AFTER THE FIRST USE AND PERIODICALLY THEREAFTER CHECK THE
ANCHOR CHAINS AND ADJUST IF NECESSARY.