12 install the end fittings & uprights – Jaypro Sports FBGP-820AX User Manual
Page 22
WWW.JAYPRO.COM
Page 22
11/1/13
3. Thread the ¼”-20 jam nut onto the eye-bolt, and thread the eye-bolt into the
upright cap.
4. Tighten the jam nut against the end cap.
5. Repeat the above steps for the other wind streamers.
Figure 11: Installing the wind streamers
12 Install the End Fittings & Uprights
Follow the steps below to install the end fittings and uprights (See Figure 12).
12.1
Preliminary Installation of First Upright and End Fitting
1. Insert one end fitting into one end of the crossbar.
a. It is recommended that you lubricate the end fitting and the inside of the
crossbar with white lithium grease.
Key
1—42-inch streamer
2—endcap
3—1/4”-20 hex nut
4—1/4”-20 eye bolt
5—#43 x 2-inch S-hook