Jaypro Sports FBGP-600 User Manual
Page 7

6
Install wind streamers (if purchased).
Remove the hardware holding the end fitting and rotate it down so the top upright can be
slid on. Using the 3/8” hardware provided attach the upright to the end fitting. It is
recommended that a silicon sealant be used on both sides of the hardware to prevent
corrosion. Once the top upright is connected, balance the top upright on a ladder, so the
upright can be pulled to vertical and fastened.
Rotate top upright into position:
Attaching top upright to end fitting. See Figure 3
Rotate the upright into position with two people on the scaffolding, one person pulls the
top upright to vertical while the second person installs the ½” hardware, silicon each side
of the fastener to prevent corrosion during installation.
Once complete, repeat on the other side. After both goalposts are installed use yellow
rustoluem to paint all of the bolt heads and all of the nuts. This will give the fasteners an
extra layer of protection and it will give the goalpost a finished look, and also touch up
any scratches.