Jaypro Sports FNFB-40 User Manual
Page 6

Rev: -
Page 6 of 8
Install Poles:
Before inserting the poles into the sleeves, check to make sure:
1. The cleat is installed opposite of pulley.
2. Run the hoisting rope thru pulley
a. Cleat both ends of rope (loosely).
It is suggested that the wild end of the hosting rope be passed thru the opening of the
cleat and a figure eight stop knot be tied at the end of the rope. This will avoid the line
from getting out of reach for the operator or worse the line inadvertently coming off the
pulley during a game. The pole slides into the ground sleeve.
Net:
Lay the net out lengthwise and cut the 3/16” coated aircraft cable to length, extending
each end enough to make up the loop. Make up a loop, as shown in Figure 6, on both
ends of the cable. Attach a cable to both the top and bottom edges of the net using the
cable ties.
Figure 6
1/4" WIRE ROPE THIMBLE with (2X) 1/4" WIRE ROPE CLIPS
STRIP OFF VINYL COATING ON AIRCRAFT
CABL
NET (SIZED PER ORDER)
8" BLACK CABLE TIE (SPACE 12” ON CENTER)
Make up the ends: