Cisco 6200 - Manual (Page 18)

1
Hardware Description 78-5296-02 10/02/98
Cisco 6200 User Guide 1-18
Table 1-6 NTC STM-1 Specifications
1.4 Management Processor Card (MPC)
The Cisco 6200 is controlled and managed by the MPC.
1.4.1 Functional Description
The MPC performs management and storage tasks for the Cisco 6200 DSLAM. The MPC provides
•
The Cisco IOS command line interface (CLI) for configuration and monitoring
•
An SNMP agent for communicating between the Cisco 6200 and the PC running the Cisco 6200
Manager software
•
Alarm contacts and environmental monitoring of key system resources
•
Line card configuration and fault polling
•
Nonvolatile storage of configuration information
•
Two PCMCIA Flash slots for storage of software images and configuration data
Specification Description
External interface One SDH STM-1 (155 Mbps). Single-mode
(intermediate reach) and multimode STM-1
versions available
Connector type SC
Fiber types • Single mode (up to 15 km)
• Multimode (up to 2 km)
Average transmitted power • Single mode: –11.5 dBm
• Multimode: –17 dBm
Average received power • Single mode: –28 to –8 dBm
• Multimode: –30 to –14 dBm
Transmission distances • Single mode: up to 15 km (9.2 miles)
• Multimode: up to 2 km (1.2 miles)
Wavelength (both modes) 1310 nm
Level 2 protocol ATM
Timing Loop timed
Internal interface 16-bit parallel bus at 10 Mbps (160 Mbps
total throughput)
Internal hardware • Motorola MC68360
• 0.5M of PROM
• 4M of RAM
• Odetics SDH interface
Dimensions
(width x height x depth) 1.5 x 15.75 x 9.75 in
(3.8 x 40.0 x 24.8 cm)
Weight 2 lb (0.9 kg)
Power consumption 26W