Jaypro Sports BGLC-7500BK - Manual (Page 22)

Rev-A Page 22 of 24
SET-UP AND TRANSPORT
Raising and Lowering the Upper Cage:
NOTE: At least two people are required for the following steps.
Caution: Keep body parts clear of pinch points between pipes and fittings.
1. Two struts are required to raise and support each arch. The raising of each arch must be done
in tandem, with equal pressure and extension.
2. Attach one end of two struts to top front frame horizontal pipe, secure in place with a quick
release pin or locking claw. Space these apart so that one of the struts is attached at each end
of the horizontal frame pipe.
3. Push up and forward on each of the struts attached in the previous step; front section of frame
should be moving easily and without binding while raising struts.
Caution: Watch for any binding of frame and/or netting while doing this, stop immediately if
anything is caught on frame hardware. Take extreme care while doing these steps to prevent
frame and/or net damage.
4. Place bottom end of struts onto next folding frame section, and secure in place with quick
release pins or locking claw.
5. Take two more struts and place inboard of the previous two struts on the second frame folding
section horizontal pipe. Secure using quick release pins or locking claw.
6. Push up and forward on each of the struts from the previous step; front and second sections of
frame should be moving up and forward easily without binding while raising struts.
7. Repeat for the next frame section.
8. Attach the final two struts and move the entire upper frame into position. The entire front of
cage may now begin to pull forward due to gravity at this point, and will come to rest on the
ground.
9. Place the bottom clamp onto top pipe of the lower frame, and secure in place with quick
release pins or locking claw. Some effort may be required to seat these last two fittings in
place, depending on net tension and the ground formation in your assembly working area.
10. To disassemble, or ‘fold’, unit – reverse above steps. Use caution when lowering the frame
sections to avoid injury.
After each use inspect all fittings, hardware, pipes, and net for integrity and tightness. Any damage or
loose hardware may result in unsatisfactory performance or failure, Contact factory or dealer for
replacement parts.