Jaypro Sports BGLC-7500BK - Manual (Page 19)

Rev-A Page 19 of 24
Attach net:
Description: The outer perimeter of the net is to be fully laced to both the front arch and the top
member of the lower frame. (See detail showing how to lace if unfamiliar with lacing). The net will
be suspended off the center two arches, by about 6”.
1. Cut a couple dozen 18” long cords from the roll of 1/8” black cord.
2. Remove the net and spread it out in front of the cage.
3. Locate the tags that call out the FRONT CORNERS, FRONT TOP and MIDDLE BACK.
4. With the frame in the folded position, take the section labeled FRONT TOP and position it in
the center of the top center crossbar. Using one of the temporary cords tie off the net to the
crossbar. Using additional cord pieces, tie off the leading edge of the net every couple of feet
to either side of the center. Continue tying off the net, working towards the front.
5. When done, verify that the net is truly centered and the labels, LEFT FRONT CORNER and
RIGHT FRONT CORNER (when looking into the cage), are in the proper corners. Note: If the
labels are reversed it means the net is upside down and the baffle will end up on the wrong side
(outside) of the cage – reverse the net if needed.
6. Shift the net, from side to side, as needed to center it.
7. Once the net is properly centered, go back to the TOP FRONT center point and lace the
leading edge of net securely to the front arch. Starting from the center, lace to one side and
then the other.
8. After the net is fully laced to the front arch – from the rear of the cage, carefully raise the front
arch section using two struts.