Intex Deluxe Maintenance Kit 2011 - Manual (Page 16)

(80PO) FLOATING SURFACE SKIMMER ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 07/23/2010
97PO
S AVE THESE INSTRUCTIONS
Page 16
POOL VACUUM OPERATING INSTRUCTIONS
English
POO
L
VAC
UU
M
OP
E
RATING
IN
S
TR
U
CTION
S
1. The filter pump is an airtight system. To eliminate air trapped in the hose
or in the pump, turn the top air release valve 1-2 turns in a
counter-clockwise motion to open the valve.
2. When water starts flowing out of the air release valve hole, screw in the
air release valve back into the filter housing cover. Do not over tighten
the valve.
3. Connect the filter pump to the power outlet and turn ON the pump.
4. In soft gentle strokes "sweep" the entire bottom surface of the pool liner
until it’s clear of debris.
5. Make sure the filter pump is turned off, and disconnect the power cord
from the electrical outlet. Remove the pool vacuum from the pool.
6. Using the Set-Up instructions in reverse, disassemble the vacuum
cleaner. Clean the debris bag if necessary.
7. Store the pool vacuum in an area where it will not be a safety hazard.
If you experience low suction on the vacuum, check that all of
the air has been removed from the hose. If you still have a low
suction problem, please review the Troubleshooting Guide for
your filter pump under "Filter pump does not pump water or flow
is very slow". Also, check that the debris bag is clean.
IMPORTANT