Intex CHALLENGER 2 BOAT SET 2011 - Manual (Page 7)

93PO
(93PO) "NMMA" BOAT W/O MOTOR MOUNTING (TYPE I) ENGLISH 7.5” X 10.3” 08/04/2010
SAVE THESE INSTRUCTIONS
Page 7
1. Insert “Shaft A” with the pin end first into the blade. Make sure the pin is securely fastened to the
blade.
2. Insert the assembled “Shaft A” through the oar-lock with the blade towards outboard (water).
3. Place the retainer ring onto the other end of the assembled “Shaft A”, from inside of the boat.
4. Join “Shaft A” with “Shaft B” together by inserting them together into the coupler and tighten the
coupler covers securely.
5. When the oars are not in use secure the oars onto the oar holders located on each side of the
boat.
Oar Assembly:
Pin
Coupler Cover
Shaft B
Coupler
Shaft A
Blade
Retainer Ring
FRENCH OARS: