Intex CHALLENGER 2 BOAT SET 2011 - Manual (Page 4)

93PO
(93PO) "NMMA" BOAT W/O MOTOR MOUNTING (TYPE I) ENGLISH 7.5” X 10.3” 08/04/2010
SAVE THESE INSTRUCTIONS
Page 4
Europe hull identification number (HIN).
USA hull identification number (HIN).
Manufacturer’s recommended maximum load capacity.
Maximum person’s capacity.
Manufacturer’s name and country of origin.
Model name and number.
Manufacturer’s recommended working pressure.
NMMA (for USA only) certification means that the boat, sold in the United States, has been
judged by the National Marine Manufacture’s Association to be in compliance with the U.S.
Coast Guard Regulations and American Boat and Yacht Council (ABYC) standards and
recommended practices.
6
5
4
3
2
1
Manufacturer’s Recommendation
The total number of persons and total weight shall not exceed the limits printed on the boat. Please refer to
the boat's hull label for the actual values of your boat.
BOAT LABEL FORMAT
7
ISO 6185 PART 1 TYPE
Do not overinflate or use high pressure air
compressor to inflate.
Adults should inflate the chambers with cold air in
numbered sequence.
This boat not rated for propulsion by a motor.
Use the enclosed ruler to check while inflating.
Nicht zu stark aufblasen und keinen Kompressor
zum Aufblasen verwenden.
Erwachsene sollten die kammern in der
angegebenen Reihenfolge mit kalter luft aufblasen.
Das Boot kann nicht durch einem Motor betrieben
werden.
Verwenden Sie das belgefügte Meßgerät um die
korrekte Füllung zu überprüfen.
Ne pas surgonfler. Ne pas utiliser de compresseur
pour le gonflage.
Le gonflage doit être effectué par un adulte avec de
l'air froid en suivant les étapes suivantes.
Ce bateau n'est pas adapté pour être équipé d'un
moteur.
Utiliser la règle jointe pour ajuster le gonglage de la
chambre à air principale.
MAXIMUM CAPACITIES
MAXIMUM-KAPAZITÃT
CAPACITÉS MAXIMUM
PERSONS
PERSONEN
PERSONNES
MANUFACTURER
HERSTELLER
FABRICANT
MODEL
MODELL
MODÈLE
RECOMMENDED WORKING PRESSURE FOR EACH CHAMBER
EMPFOHLENE ARBEITENDE DRUCK FÜR JEDE LUFTKAMMER
RECOMMANDÉ FONCTIONNEL PRESSION POUR CHAQUE CHAMBRE À AIR
CN-XEE ________
BY INTEX ®
LOAD CAPACITY
BASIC FLOTATION
___Kg ( ___ Lbs) MAX.
National Marine Manufacturers Association
+ = ___ Kg ( ___ Lbs)
____________________
= ___ bar ( ___ psi)
CHINA
1
3
4
5
6
7
8
MAXIMUM CAPACITIES
PERSONS OR ____kg (___Lbs)
____ ____ POUNDS, PERSONS, GEAR
= ___ = ___
DESIGN COMPLIANCE WITH NMMA REQUIREMENTS BELOW IS VERIFIED.
MFGR. RESPONSIBLE FOR PRODUCTION CONTROL
XEE ________
2
8