Intex PURESPA 77" BUBBLE MASSAGE SPA 2014 - Manual (Page 11)

254
PO
S AVE THESE INSTRUCTIONS
(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/18/2013
English
Page 11
OPERATION
SPA CONTROL UNIT PANEL
On/Off Button: Once the unit is plugged in, use this button to active the control unit panel
buttons. The light next to the button is green when activated. Press this button to turn off all
currently activated functions.
Heat Button: Use this button to activate the heating system. The pump will heat the spa water
until the water temperature reaches the set temperature. After the current water temperature
drops 2°F below the set temperature the heating system will restart. When the fl ame icon on the
display is red, the heating system is activated. When the fl ame icon turns green, the water is at
the set temperature and the heating system is at rest.
NOTE: If the heating system is activated the fi ltration system will automatically start.
NOTE: After turning off the heating system the fi ltration system will continue to operate 24 hours.
Celsius/Fahrenheit Toggle button:
The temperature can be displayed in either Fahrenheit or Celsius. The system’s default is
Celsius.
CAUTION: NEVER use the spa if indicated water temperature is more than 104ºF (40°C).
Temperature Adjustment Buttons: Pressing the Temperature Increase or Decrease
buttons will cause the LED to fl ash. When fl ashing you can adjust to the desired temperature
setting. If you hold these buttons down the values will rapidly increase or decrease. The new
and desired temperature setting will remain on the LED display for 5 seconds to confi rm the new
value.
NOTE: The default temperature is 68°F (20°C).
NOTE: Temperature adjustment ranges from 68°F (20°C) to 104°F (40°C).
Water Filter Button:
This button turns the fi lter pump on and off.
The water fi lter icon on the display is green when activated.
Bubble Button: Use this button to activate the massage system, which has a 30-minute
auto-shutoff feature. The bubble icon on the displays is green when activated.
WARNING: Do not run Bubble system when the cover is attached, air can accumulate
inside the spa and cause irreparable damage and bodily harm.
LED Display: Once plugged in the LED displays the current water temperature automatically.
For model SSP-H-10 only: the built-in hard water treatment function works automatically in conjunction with
the fi ltration system.
IMPORTANT: The following conditions will lead to slow water heating:
• The ambient temperature is lower than 50ºF (10ºC).
• Outdoor wind speed is above 8-12 mph (3.5-5. 4m/s).
• The air bubble function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
F
104
o
A: Heat Button
B: Celsius/Fahrenheit Toggle Button
C: Temperature Increase Button
D: Temperature Decrease Button
E: Water Filter Button
F: Bubble Button
G: LED Display
H: On/Off Button
104
F
o
F
E
D
C
B
A
G
H