Intex 12 FT X 30 IN EASY SET POOL 2013 - Manual (Page 12)

(86PO) EASY SET POOL ENGLISH 7.5” X 10.3” PANTONE 295U 07/02/2012
86PO
S AVE THESE INSTRUCTIONS
Page 12
English
STORAGE
POOL MAINTENANCE & DRAINAGE
Do not add chemicals if the pool is occupied. This can cause skin or eye irritation.
Concentrated chlorine solutions can damage the pool liner. In no event is Intex Recreation
Corp., Intex Development Co. Ltd., their related companies, authorized agents and service
centers, retailers or employees liable to the buyer or any other party for costs associated
with the loss of pool water, chemicals or water damage. Keep spare filter cartridges on
hand. Replace cartridges every two weeks. We recommend the use of a Krystal Clear™
Intex Filter Pump with all of our above-ground-pools. To purchase an Intex Filter Pump or
other accessories see your local retailer, visit our website or call the Intex Consumer
Services Department listed in the separate "Authorized Service Centers" sheet and
have your Visa or Mastercard ready.
EXCESSIVE RAIN: To avoid damage to the pool and over filling, immediately drain rain
water that causes the water level to be higher than the maximum.
How to Drain Your Pool and Long Term Storage
1. Check local regulations for specific directions regarding disposal of swimming pool water.
2. Check to make sure that the drain plug inside the pool is plugged in place.
3. Remove the cap from the drain valve on the outside pool wall.
4. Attach the female end of the garden hose to the drain connector (4).
5. Place the other end of the hose in an area where the water can be safely drained away
from the house and other nearby structures.
6. Attach the drain connector (4) to the drain valve. NOTE: The drain connector will push
the drain plug open inside the pool and water will start to drain immediately.
7. When the water stops draining, start lifting the pool from the side opposite the drain,
leading any remaining water to the drain and emptying the pool completely.
8. Disconnect hose and adapter when finished.
9. Re-insert drain plug in drain valve on inside of pool for storage.
10. Replace drain cap on outside of pool.
11. Completely deflate the top ring, and remove all connecting parts.
12. Be sure that the pool and all parts are completely dry before storage. Air dry the liner in the
sun for an hour before folding (see drawing 8). Sprinkle some talcum powder to prevent
the vinyl from sticking together and to absorb any residual moisture.
13. Create a square shape. Starting at one side, fold one-sixth of liner into itself twice.
Do the same on the opposite side (see drawings 9.1 & 9.2).
14. Once you have created two opposing folded sides, simply fold one over the other like
closing a book (see drawings 10.1 & 10.2).
15. Fold the two long ends to the middle (see drawing 11).
16. Fold one over the other like closing a book and finally compact the liner (see drawing 12).
17. Store the liner and accessories in a dry, temperature controlled, between 32 degrees
Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius),
storage location.
18. The original packing can be used for storage.
10.1
8 9.1 9.2
10.2 11 12
CAUTION ALWAYS FOLLOW THE CHEMICAL MANUFACTURER'S
DIRECTIONS, AND THE HEALTH AND HAZARD WARNINGS.