Intex 12 FT X 30 IN EASY SET POOL 2013 - Manual (Page 10)

(86PO) EASY SET POOL ENGLISH 7.5” X 10.3” PANTONE 295U 07/02/2012
86PO
S AVE THESE INSTRUCTIONS
Page 10
English
SETUP
INSTRUCTIONS
POOL SETUP (continued)
4. Filling of the pool
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and
that the drain cap on the outside is screwed on tightly. Fill the pool with no more than 1
inch of water. Check to see whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely
level. Setting up the pool on unleveled ground will cause the pool to tilt resulting
in the sidewall material to bulge and a potential collapse of the pool. If the pool is
not completely level, you must drain the pool, level the area and re-fill the pool.
• Smooth out the bottom liner wrinkles (from inside
the pool) by pushing out where the pool floor
and pool sides meet. Or, (from outside the pool)
reach under the side of the pool , grasp the pool
floor and pull in an outward direction. If the ground
cloth is causing the trouble, have 2 adults pull from
opposite sides to remove all wrinkles (see
drawing 4).
• Now fill the pool with water. The pool liner walls
will rise while you are filling it (see drawing 5).
• Fill the pool with water up to the bottom of the
inflated ring which is the recommended fill line
level (see drawings 1 and 6).
IMPORTANT
Before allowing anyone to use the pool, hold a family meeting. Establish a set of
rules that include, at a minimum, the important safety rules and general
aquatic safety information in this manual. Review these rules on a regular basis
and with all users of the pool, including guests.
4
5
6