Campbell Hausfeld Finishing Nailer JB006750 - Manual (Page 6)

6
Model JB006750 Operating Instructions
Fasteners
The following Campbell Hausfeld finishing nails are available at local retail stores. If you need help locating any item,
call customer service at 1-800-543-6400. Campbell Hausfeld nails meet or exceed ASTM Standard F1667.
Shank Nails Per Nails Per
Model # Length
Gauge
Finish Head Collation
Stick Box
FB003060 1-1/4” 16 Gauge Galvanized Brad Adhesive 50 2500
FB004060 1-1/2” 16 Gauge Galvanized Brad Adhesive 50 2500
FB004560 1-3/4” 16 Gauge Galvanized Brad Adhesive 50 2500
FB005060 2” 16 Gauge Galvanized Brad Adhesive 50 2500
FB006560 2-1/2” 16 Gauge Galvanized Brad Adhesive 50 2500
FB160025 1" 16 Gauge Galvanized Brad Adhesive 50 1000
FB160040 1-1/2” 16 Gauge Galvanized Brad Adhesive 50 1000
FB160050 2" 16 Gauge Galvanized Brad Adhesive 50 1000
FB160065 2-1/2” 16 Gauge Galvanized Brad Adhesive 50 1000
Interchange Information
Nails used in the Campbell Hausfeld JB006750 Finishing Nailer will also work in Hitachi NT65A, Paslode 3250-F16, IM250F,
Duo Fast LFN-764, Sears 18321, Porter Cable FN200, FN250 and Campbell Hausfeld NB0064.
www.chpower.com
Air leaking at trigger valve
Air leaking between hous-
ing and nose
Air leaking between hous-
ing and cap
Nailer skips driving nail
Nailer runs slow or has loss
of power
Nails are jammed in nailer
O-Rings in trigger valve housing are
damaged
Loose screws in housing
Damaged O-Rings
Damage to bumper
Loose screws
Damaged gasket
Worn bumper
Dirt in nose piece
Dirt or damage prevent nails or pusher
from moving freely in magazine
Damaged pusher spring
Inadequate air flow to nailer
Worn O-Ring on piston or lack of lubri-
cation
Damaged O-Ring on trigger valve
Air leaks
Cap gasket leaking
Nailer not lubricated sufficiently
Broken spring in cylinder cap
Exhaust port in cap is blocked
Guide on driver is worn
Nails are not correct size
Nails are bent
Magazine or nose screws are loose
Driver is damaged
Replace O-Rings. Check operation of Work Contact
Element (WCE)
Tighten screws
Replace O-Rings
Replace bumper
Tighten screws
Replace gasket
Replace bumper
Clean drive channel
Clean magazine
Replace spring
Check fitting, hose or compressor
Replace and lubricate O-Rings
Replace O-Rings
Tighten screws and fittings
Replace gasket
Lubricate nailer
Replace spring
Replace damaged internal parts
Replace guide
Use only recommended nails
Replace with undamaged nails
Tighten screws
Replace driver
Troubleshooting Guide
Stop using nailer immediately if any of the following problems occur. Serious
personal injury could result. Any repairs or replacements must be done by a Qualified Service
Person or Authorized Service Center.
Problem Cause Solution