Campbell Hausfeld Finishing Nailer JB006750 - Manual (Page 5)

3. Insert a stick of
Campbell
Hausfeld nails
or equivalent
(see Fastener
Section) into the magazine. Make
sure the pointed ends of the nails are
resting on the bottom ledge of the
magazine when loading. Make sure
the nails are not dirty or damaged.
4. Push the maga-
zine cover for-
ward until the
latch catches.
5. Always unload all fasteners before
removing tool from service.
Unloading is the reverse of loading,
except always disconnect the air
hose before unloading.
ADJUSTING THE NAIL PENETRATION
The tool is equipped with an adjustable
depth of drive feature. This allows the
user to determine how deep a fastener
will be driven into the work surface.
1. Adjust operating pressure so nails
are driven consistently. Do not
exceed 110 psi.
2. To drive the nail shallower, turn the
wheel (C) to left to the extent
desired.
3. To sink a nail deeper, turn the wheel
(C) to right to the extent desired.
4. Make sure trigger
and work contact ele-
ment (WCE) move
freely up and down
without binding or
sticking after each adjustment.
ADJUSTING THE DIRECTION OF THE
EXHAUST
The tool is
equipped with an
adjustable direc-
tion exhaust
deflector. This is intended to allow the
user to change the direction of the
exhaust. Simply twist the deflector to
any direction desired.
CLEARING A JAM FROM THE NAILER
1. Disconnect the
air supply from
the nailer.
2. Remove all
nails from the
magazine (see
Loading/
Unloading).
Failure to do so will cause the nails
to eject from the front of the tool.
3. Undo latch by
pulling out and
down. The wire
latch will disen-
gage from the
hooks on the nose.
4. The door can
now be rotat-
ed, exposing
the jammed
fastener.
5. Remove the
jammed fasten-
er, using pliers
or a screwdriver
if required.
6 Rotate door
back into the
closed position.
7. Extend the
wire latch and
place over the
hooks on the
nose.
8. Close the latch
by pushing the
latch up and in
until the latch
snaps into place.
9. Make sure the
trigger and
work contact
element (WCE)
move freely up
and down without sticking or binding.
Technical Support
Please call our Nailer Hotline at 1-800-
543-6400 with any questions regarding
the operation or repair of this nailer or
for additional copies of this manual.
Fastener And Replacement
Parts
Use only
genuine
Campbell Hausfeld 16 gauge fasteners
(or equivalent) - see Fastener
Interchange Information. Tool perfor-
mance, safety and durability could be
reduced if improper fasteners are used.
When ordering replacement parts or
fasteners, specify by part number.
Nailer Repair
Only qualified personnel should repair
the tool and they should use genuine
Campbell Hausfeld replacement parts
and accessories, or parts and acces-
sories which perform equivalently.
Assembly Procedure For
Seals
When repairing a nailer, the internal
parts must be cleaned and lubricated.
Parker O-lube or equivalent must be
used on all o-rings. Each o-ring must be
coated with O-lube before assembling.
A small amount of oil must be used on
all moving surfaces and pivots. After
reassembling, a few drops of 30W non-
detergent oil or equivalent, must be
added through the air line before
testing.
Model JB006750 Operating Instructions
5
www.chpower.com
(C)
Rotate
Operating The Nailer
(Continued)
movement