Char-Broil 463244011 - Manual (Page 20)

7
8
Insert flange on left side shelf into side shelf brackets on side of firebox.
Fascia, left sideburner shelf
Left sideburner shelf
Flange
into
Brackets
Bracket
First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia. Attach using two #8-32x3/8” screws and 4mm lock washers. Press sideburner control knob onto valve stem.
Control knob
Control knob bezel
Install bezel with “OFF” at top.
Sideburner
valve bracket
Screws and Washers
removed from valve bracket
Valve stem
#8-32x3/8” screw
4mm lock washer
Sideburner
fascia
Note: Use left and right
holes on fascia to
attach valve bracket
Note: Use upper and lower
holes on fascia to
attach bezel
20
Attach rear of shelf using one screw, 7mm lock washer, and 7mm
Attach left side shelf using four 1/4-20x3/4” screws, 7mm lock washers, 7mm flat washers, 1/4” nuts, shown A.
flat washer in lower hole, shown B.
flat washer, shown C. Attach front of shelf and fascia using one #8x3/8” self-tapping screw and large
Fully tighten lower screws on upper back panel.
1/4-20x3/4”
screw
screw
washer
washer
7mm flat washer
7mm lock washer
#8x3/8” self-tapping
large flat
washer
7mm lock 7mm flat
1/4”nut
A
B
C
screw
1/4-20x1½”
1/4-20x1½”