Philips AZ 6892 - Manual (Page 5)

INSTALLATION MAINTENANCE
POWER SUPPLY GENERAL MAINTENANCE
Batteries
• Press BATTERY RELEASE to release the battery
holder and insert as indicated four (preferably
Alkaline) batteries, type R6, UM3 or AA-cells, see
fig. 1. You may also use rechargeable Nickel-Cad­
mium batteries.
• Remove the batteries if exhausted or if they are not
te be used again for a long period.
The battery supply is switched off when the 7 V DC
socket is in use. When changing over to battery
supply, pull out the plug from the 7 V DC socket.
7 V D C socket
• At home, use the supplied mains adapter
EM 1030, delivering 7 V/350 mA Direct Current. Use
only the supplied mams adapter, since serious
damage may occur if another adapter is used.
• Check that the mains voltage of the mains adapter
corresponds to your local mains supply. If not,
consult your dealer or service organisation. If the
mams adapter is equipped with a voltage selector,
set this selector to the local mains voltage.
• Connect the mains adapter to the 7 V DC socket
and the wall socket. Remove the mains adapter from
the wall socket when the set is not in use.
-The mechanism of the CD-player is fitted with
self-lubricating bearings and therefore must not be
oiled or greased.
- Rngerprints, dust and dirt on the apparatus can be
removed using a soft, clean and slightly damp
leather cloth. Do not use any cleaning agents which
contain abrasives or solvents such as benzine
thinner, alcohol, refined petrol or ammonia, since
they may affect and harm the cabinet.
- Do not expose the set, batteries or discs to rain or
moisture, or, for any great length of time, to excessive
heat from heating equipment or direct sunshine, e.g.
in cars parked in the sun.
- Keep the set and the discs away from sand.
CD-PLAYER AND DISCS
CONNECTIONS
-The lens ® (fig. 3) should never be cleaned.
-The lens may steam up when the set is taken from
a cold into a warm environment. Playing a disc is not
possible then. Do not clean the lens, but let the set
acclimatize for a while.
- Always pick up the disc by the edge and put it back
in its box immediately after use.
- To remove dirt from a disc, first breathe on the disc
and wipe it off in a straight line from centre to edge
(fig. 4) using a soft, lint-free cloth. The use of cleaning
agents may harm the disc.
Headphone socket IHI/LINE OUT
• For stereo headphones (or mini loudspeakers)
with 3.5 mm plug.
• For CD-reproduction through your stereo system
(amplifier, receiver, recorder, etc.). Connect the
supplied signal lead to the ¡Hl/UNE OUT socket and
to the input sockets REC IN, TAPE IN, LINE IN, AUX
or CD IN of the other set.
The output signal is adjusted with the VOLUME
control and the DBB BASS button.
This product complies with the radio interference
requirements of the European Community.
The type plate is located on the base of the set.
REMOTE socket
• For the supplied remote control with the functions
PLAYt>, PAUSE on, STOP and 1