Philips AZ 1102 - Manual (Page 6)

OPERATION TUNER
GENERAL OPERATION
7. To switch on the set, use the source selector®
2. Adjust the sound using the VOLUME control ® and DBB switch
3. To switch off the set, set the source selector ® to TAPE/OFF posi­
tion, with the cassette keys reieased.
TUNER
7. Set the source selector @ to TUNER.
Z Adjust the sound using the VOLUME control ® and the
DBB switch
3. Select the wave band using the FM-MW band seiector ®.
4. Tune to a radio station using the TUNING knob ®.
- For FM, pull out the telescopic aerial. To improve FM-reception,
incline and turn the aeriai. Reduce its length if the FM-signal is
too strong (very close to a transmitter).
- For MW the set is provided with a built-in aerial, so the telescopic
aerial is not needed. Direct the aerial by turning the whole set.
- The FM STEREO indicator® lights up when you are receiving a
FM stereo transmitter in stereo.
5. To switch off the set, set the source selector @ to TAPE/OFF posi­
tion, with the cassette keys released.