Cabletron Systems 7F06-02 - Manual (Page 22)

INSTALLATION/REMOVAL
3-7
3.3.4 Removing from the 7C04 or 7C04-R Workgroup
SmartSwitch
The 7F06-02 Module, inserted in the 7C04 or the 7C04-R
Workgroup SmartSwitch, can be removed whenever necessary.
Follow the steps below and refer to the appropriate figure to
remove the module.
Note: Before removing the 7F06-02 module, attach the wrist strap
included with the SmartSwitch or SmartSwitch module by
following the instructions printed on the package.
1. Use a slotted screwdriver to loosen the two screws that secure the
module to the chassis.
2. Locate the two ejector tabs on the module (below the screws on the left
and right end of the module).
3. Simultaneously press left on the left ejector tab and right on the right
ejector tab until the module ejects from the backplane.
4. Grasp both ejector tabs and carefully slide the module out of the
chassis.
Figure 3-6. Removing the 7F06-02 Module from the 7C04 Workgroup
SmartSwitch
SP
1
2
3
4
P S P S SP
PW
R
CP
U
SP
Screws
Ejector Tabs