Cabletron Systems 7F06-02 - Manual (Page 19)

3-4
INSTALLATION/REMOVAL
Note: Before removing the 7F06-02 module, attach the wrist strap
included with the SmartSwitch or SmartSwitch module by
following the instructions printed on the package.
1. Use a slotted screwdriver to loosen the two screws that secure the
module to the chassis.
2. Locate the two ejector tabs on the module (to the right of the screws on
the top and bottom of the module).
3. Simultaneously press down on the bottom ejector tab and up on the
top ejector tab until the module ejects from the backplane.
4. Grasp both ejector tabs and carefully slide the module out of the
chassis.
Figure 3-3. Removing the 7F06-02 Module from the 7C03 MMAC
SmartSwitch
PWR
SN
MAC ADR
A
P
S B
A
SN
B
F
D
D
I
1
A
D
D
F
I
2
B
7F00 7X00
P
S B
A
P
S B
A
7E03-24
SN
CPU
Screws Ejector
Tabs