Philips AJ3720 - Manual (Page 7)

SETTING DATA RADIO
TIME ZONE SETTING
This feature allows you to set the clock display with up to 2 hours
difference from normal local time. The TIME ZONE setting can be
useful when you want to change to or from summer time if there
is a seasonal time difference. However, make sure the time zone
is set at 00;00 if there is no time difference.
1. Press the WEEKEND SLEEPER/ timezone button once.
— If the display shows the time zone setting 00:00, no time
difference has been selected.
2. Press TUNING / r« or briefly to select up to -2:00 or
2:00 hours difference respectively.
3. Press the WEEKEND SLEEPER/ timezone button twice if you
wish to exit the time zone display immediately.
Note: If you press the WEEKEND SLEEPER/ time zone button
twice before adjusting the time difference, the display
will show 'Auto' or 'Std.'.
- The 'Auto' and 'Std' function is available on the AJ 3740
version only.
• Press WEEKEND SLEEPER/ time zone
again until you re­
enter the time zone display.
RADIO RECEPTION
When you switch on the radio, the last preset or station tuned to
will be heard.
1. Press RADIO ON to switch on the radio mode.
-*The radio frequency and waveband appear in the display
for 10 seconds before reverting back to the clock display.
Press RADIO ON again if you want to view the radio
display.
2. Adjust the BAND switch to select the waveband.
3. Tune to the station either manually, automatically o: by
using the presets.
To improve radio reception
FM: extend the pigtail wire at the back of the set
completely for optimum reception.
MW/LW: uses a built-in antenna. Direct the antenna by
adjusting the position of the set.
4. Adjust the sound using the VOLUME control.
5. To switch off the radio, press ALARM RESET/RADIO OFF.
—The display reverts to showing the clock time.