Philips AJ 3940/05 - Manual (Page 3)

RMNO RECEPTION
f. Press RADIO on to switch on the radio mode.
- The RADIO indicator appears in the display.
2 Adjust the BAND switch to select the waveband.
3. Use the TUNING control to find your station.
To improve radio reception
FM; extend the pigtail antenna at the back of the set
‘ ••••••
1
/ A -X —- - “
l(l'i 1 m
completely for optimum reception.
MW{LW): uses a built-in aerial. Direct the aerial by
adjusting the position of the set.
4. Adjust the sound using the VOLUME and DBB controls.
5. Press ■ OFF to switch off the radio.
— The RADID indicator disappears from the display and the
radio is switched off.
j 1 Í j
li 1
i
r
/!/
SETTING THE AURM TIME
General
Two different alarm times ALM 1 or ALM 2 can be set in a -
variety of modes. This can be useful when for example you need
to be woken up at a different time during the week or at the
weekend.
Note: The ALM 1 or 2 button should be held down throughout
■ %. • .................._
steps 1-4 below.
SETTING ALARMI OR 2
I. Press and hold down the ALM 1 or 2 button.
— day appears in the display if you have not set the day
(see SEHING THE DAY)
2 Press or to set and adjust both the hours and minutes:
- With h« or pressed, the display will increase or
decrease the alarm time rapidly and continuously from
minutes to hours.
- Press m or briefly and repeatedly to adjust the alarm
time minute by minute.
3. Release or ►*( when you have reached the correct alarm
time setting.
4. Select your choice of alarm mode by pressing CD ►, BUZZER
or RADIO
5. Release the ALM 1 or 2 button.
— The display will show the selected alarm icon or
© under A ALM 1 or T ALM 2.
6. To review the alarm time, press your selected ALM 1 or 2
button.
IMPORTANT!
If you want the alarm to wake you up. FIRST CHECK if:
- you have adjusted the volume loud enough when using the
CD / TRACK SELECT/ RADIO alarm modes:
- you have disconnected the headphones:
- the loudspeakers are switched on if you are using amplified
loudspeakers in the headphone socket.
SETTING TRACK SELECT
You can program and set a TRACK SELECT number between
01-99, when the set is in the standby mode or during CD
playback.
However, if the track number programmed does not exist on your
CD, the first track of the CD will be played during the alarm call.
1. Insert a CD into the CD compartment
2. Press and hold down the selected ALM 1 or 2 button and set
your alarm time using the or»w controls.
3. Before releasing ALARM, press the CD P- button.
- The display will show the CD icon 0 under A ALM 1 or
T ALM2
4. Hold down the TRACK SELECT button and select your track
number by pressing M4 or » m
5. Release the TRACK SELECT and SEARCH r« or controls
when you have found the desired track number.
6. To review your programmed track number, press TRACK
SELECT again.
- The selected track number and alarm number will be
shown.
Note:
- The BUZZER alarm option will automatically replace the CD /
TRACK SELECT alarm if you have:
- inserted a CD incorrectly:
- inserted a damaged CD:
- forgotten to insert any CD.
(/)
H
73
C
o
H
o
CO
■n
O
73
C
(/)
m
00
¿0
Tl
O
C/)
CO