Philips AJ 3940/05 - Manual (Page 2)

T)
o
to
MAINS CONNECTION
1. Check if the power supply as shown on the type plate (on the
bottom of the set) corresponds to your local power supply. If it
does not, consult your dealer or service centre.
— If your set is equipped with a voltage selector, found on the
bottom right-hand corner of the set, adjust the selector to
correspond with your local power.
2. Connect the power plug to the wall outlet.
— The power supply is now switched on and the numbers on
the display will start to flash. You will need to set the
correct time.
3. To switch off the power supply completely, pull the mains plug
out of the wall outlet.
Power breakdown
In the event of a power failure the set will be completely
switched off. Disconnect the set first and re-plug after
3 seconds or more. Most of the settings will remain in the
memory, but you will need to reset the time and day on the
clock. To retain the clock time and the set alarm time(s) in the
event of an AC power failure or disconnection, insert 3x
AAA-6/UM3 batteries (not supplied) into the the battery
compartment: this will act as a power backup. However, the
time will not be illuminated on the clock display. Operation of
the alarms, CD player and radio are also excluded. For clarity,
the battery backup is used to retain the set clock and
alarm time(s) only. As soon as the power supply returns, the
set will resume the standby mode and the display will indicate
the correct time.
1. Connect the mains plug to the wall outlet.
2. Insert the batteries into the battery compartment
• Replace the batteries at least once a year to prevent battery
leakage, or as often as necessary according to power
breakdown usage.
Batteries contain chemical substances, so they should be
disposed of properly
Connecting headphones / loudspeakers
Connect headphones / active loudspeakers with a 3.5 mm plug
into the T! jack.
— The built-in loudspeakers of the set will now be muted.
Illumination brightness
Press BRIGHTNESS once or more to change the brightness of
the display.
—The brightness of the display will change in this sequence:
LOW - MEDIUM - BRIGHT - LOW. ..
Clock display
The time is displayed using the 24-hour clock system.
General
The data for the clock time, date and year need to be entered
separately.
Setting the time
1. Press and hold the TIME button
2. Press r« / ►►! to set and adjust both the hours and minutes:
- with you finger held down on m or respectively, the
time will increase/decrease rapidly and continuously from
minutes to hours.
- Press or>w briefly and repeatedly to adjust the time
slowly, minute by minute.
3. Release the TIME and or ew buttons when you have
reached the correct setting.
Setting the day
After setting the clock time, you will need to set the day. This
enables you to set the alarm functions and WEEKEND SLEEPER
later.
1. Press and hold day /REPEAT ALARM.
- Du will flash in the display, or a number from 1-7
indicating the last selected day setting:
1 = Monday
2 = Tuesday
3 = Wednesday
4 = Thursday
5 = Eriday
6 = Saturday
7 = Sunday
2. While 00 flashes, press the r« or controls briefly once or
more to set the day.
3. Release day /REPEAT ALARM and r« or when you have
reached the correct day.
- The display will revert to show the clock time.
(A
H
73
C
o
H
o
z
(/)
■n
o
73
c
CO
m