Philips AJ3953 - Manual (Page 9)

UU/ KAUlU St I lINli ALAKM UKIIUIMS
Selecting a different track during playback
The track number appears briefly in the display when
you press SEARCH i+< or »i to skip tracks.
• Press SEARCH once or more to skip to the next
track(s).
• Press SEARCHu^ more than once to skip to
previous tracks.
• Press SEARCH once and playback will return to
the beginning of the current track.
Finding a passage within a track
1 During playback, press and hold down
SEARCH M4 or »> 1 .
— The CD is played at high speed and low volume:
the display will show Cd: and your current track
number.
2 Release SEARCH r« or » h when you recognize the
passage you want.
— Normal CD playback and standby clock time
resumes.
RADIO
1 Press ON/ OFF to switch on the radio.
is displayed briefly followed by the clock time
, and the last selected waveband.
2 Press FM/AM if you wish to change waveband.
3 Adjust the sound using VOLUME or A.
4 Adjust the TUNING wheel to tune to a radio station.
To improve reception:
FM: Extend pigtail at the back of the set fully for
optimum reception.
AM: uses a built-in antenna. Direct the antenna by
adjusting the position of your set.
5 Press ON/ OFF to switch off the radio.
■:T-TiTl»l and the waveband disappear from the
display.
SEHING THE ALARM OPTIONS
General
Two different alarm times, ALARM 1 or 2 can be set in
the CD, radio or buzzer modes. This can be useful when
for example you need to be woken up at a different
time during the week and at the weekend.
- Remember to first set the DAY, clock and alarm time
functions correctly I
- Make sure your selected alarm symbol is shown.
Viewing the Alarm Mode Options
1 Select your choice of alarm mode by pressing
ALARM 1 or ALARM 2 MODE/ OFF once or more to
find your respective mode.
The alarm mode display sequence is shown:
- L a :IJIJ - default volume level for start of gentle
wake alarm
- H t: 16 - default maximum volume level for
gentle wake alarm
- Followed by the 3 different alarms:
(buzzer) fl FIL, or
(radio) tu, or
CD mode ci> with CD and a track number / - S S.
2 Read the following chapters to adjust or select the
respective modes.
Adjusting the Gentle Wake Volume
A sure way of getting up in the mornings, the gentle
wake volume for the alarm begins from gentle volume
e.g L a'00 (low) and gradually increases to a higher
volume e.g. l-l /■' / t.
The default volume range is L oOJO and 0 0 IB. If
you wish to change the default volume for the buzzer,
radio or CD alarm:
1 In the standby mode, press ALARM 1 MODE/ OFF
or ALARM 2 MODE/OFF once.
2 As soon as i o:00 appears, press f or Jfonce or
more to adjust the starting volume of your alarm.
3 To set the maximum volume for your alarm, press
ALARM 1 MODE/ OFF or ALARM 2 MODE/ OFF
again to change to the H /■' /6 display.
4 As soon as A' /■' /5 appears, press 1 or ^ until you
reach the desired volume level (!0 - 3d).