CFM Corporation 2467 - Manual (Page 12)

12 12
Dutchwest Natural Vent Gas Heater
30002008
Install the Stove Front
Insert the handle stub into the hole in the front casting.
Fasten in place with the 3/8” locking nut provided. (Fig.
23)
The front attaches to the stove by four steel tabs that
engage with corresponding cast ribs onto the sides and
bottom of the stove body. Position the front about 3”
down from stove top and lift the plate to engage the
upper tabs behind the adjacent ribs on the sides. (Fig.
24) Then lower the front into position, so the lower tabs
engage with the corresponding ribs at the bottom.
When properly installed, the bottom of the stove front
cannot be pulled away from the sides without also lifting
it.
3/8”
Locking
Nut
Handle Stub
ST773
Fig. 23 Insert handle stub into hole in front. Secure with 3/8”
locking nut.
LG142
Fig. 21 Completed log installation.
Lava Rock
Fig. 21 Install the back, left and right logs.
LG141
Right
Log
Decorative Grate
Rear Log
Left Log
Engage steel
tabs behind
the cast iron
bosses
Bottom tabs engage
notch in the leg
ST780
Fig. 24 Install the front plate.
D UTCH W EST
D UTCH W EST Est. 1974