R1125t series, Installation instructions, C-ul specifications – Interlogix R1125T Series User Manual
Page 2: C-ul-us specifications, Diameter press fit with mini-max magnets, Ge interlogix
R1125T Series
3
/
8
" Diameter Press Fit with Mini-Max Magnets
Installation Instructions
Switch
1: Drill
3
/
8
"
dia. hole 1
1
/
8
"
deep for the contact.
2: Strip wire from security system loop, insert into terminal block and tighten. Test for continuity.
3: Lightly coat the contact RTV mounting compound (GE part number 1905) and insert into
respective hole.
Magnet
1: Mount magnet to double-sided tape (included) and affix to window frame.
2: Or, if using stainless steel screw (included), drill
1
/
16
"
dia. (using magnet center hole
as a guide) and mount using #4 x
1
/
2
"
stainless steel screw (included). Use caution if using
screw other than the one provided, as it will effect the gap performance.
3: Care should be taken not to over tighten screw to avoid damage to magnet or stripping hole.
Recess/Flush Mount Magnet
1: Drill
7
/
16
"
dia. hole (standard gap) or
5
/
8
"
dia. hole (wide gap) by approximately
1
/
8
"
deep .
2: Coat magnet with RTV silicon adhesive and mount into hole.
NOTE: When surface mounting magnet be sure there is enough clearance to prevent the magnet from becoming
damaged when closing the window or door.
10341402 rev A
www.GE-Interlogix.com
2266 Second Street North
North St. Paul, MN 55109
Phone: 651-777-2690
USA & Canada: 800-777-5484
Technical Service: 800-777-2624
12345 SW Leveton Drive
Tualatin, OR 97062
Phone: 503-692-4052
USA & Canada: 800-547-2556
Technical Service: 800-648-7424
Faxback: 800-483-2495
GE Interlogix
Made in Taiwan
Part
Loop
Electrical
Gap
Number
Type
Configuration
Distance
R1125T
Closed
N.O.
1
/
2
"
R1125TW
Closed
N.O.
7
/
8
"
**
European Union Specifications: 48 V AC/DC max, 0.5 Amp
**
FORM A (R1125T, R1125TW)
Voltage: 100 V AC/DC max
Current: 0.5 A max
Power: 7.5 W max
WARNING: Each electrical rating is an individual maximum and cannot be exceeded!
C-UL Specifications
Standard Gap
Wide Gap
.38"
9.5mm
1.08"
27.4mm
.44"
11.1mm
.16"
4.06mm
.44"
11.1mm
1.08"
27.4mm
.38"
.95mm
.60"
15.2mm
hole diameter:
.13"
3.3mm
hole diameter:
.13"
3.3mm
#4 Countersink
#4 Countersink
.16"
4.06mm
.38"
9.5mm
Magnet
Part No. 1830
(included)
Magnet
Part No. 1835
(included)
C-UL-US Specifications