Interlogix 2810T Series - Manual (Page 2)

** Gap distances are nominal make distance ± 20%.
Form C: (2814T, 2817T))
Voltage: 100 V AC/DC MAX.
Current: 0.3 A MAX.
Power: 3.0 W MAX.
Cycles: 10,000,000
12345 SW Leveton Dr.
Tualatin, OR 97062
Tel.: 503.692.4052 Fax: 503.691.7566
U.S. & Canada: 800.547.2556
Technical Service: 800.648.7424
FaxBack: 800.483.2495
CORPORATE HEADQUARTERS Sentrol reserves the right
to change specifications
without notice.
©1998 Sentrol
SENTROL
European Union Specifications; 48 V AC/DC Max., 0.5 Amp
C-00001198
PK-0721 Rev B
ORDERING INFORMATION
Part Loop Type Electrical Finish Gap Setup Guarded Internal
Number Configuration Distance Housing Shield
2814T Open or Closed SPDT Textured Brown .2 to .6" .4" Yes No
2817T Open or Closed SPDT Textured Brown Up to .5" .3" Yes No
INSTALLATION CONT.
7. Temporarily attach magnet to tamper proof mounting bracket
#1960, finger tight only. With door closed, hold magnet so
that the protective flange completely and squarely covers the
switch lid and switch bottom is situated exactly .3" from
magnet. Mark door for bracket installation.
Alignment is critical!
8. Remove magnet from bracket. Open door and mount bracket
as marked with provided fasteners. Reattach magnet loosely
and reclose door. Assure .3" gas distance is correct. Mark
magnet location on bracket. Open door and tighten magnet to
bracket.
9. Check outputs for correct operation.
3. Open door, remove switch lid and disconnect ohmmeter and
power leads.
4. Hold the switch in its mounting position to assure correct
alignment with magnet. Mount the switch firmly with provided
fasteners.
5. Install rigid conduit.
6. Make terminal connections as indicated in Figure 1.
7. Apply RTV mounting compound to lid and conduit hub to
prevent moisture seepage. Replace switch lid.
8. Check outputs for correction operation.
Be certain that switch and magnet line up squarely!
Because manufacturer does not install, adjust, place or operate
this security device the manufacturer cannot guarantee the
performance of this security device. Therefore, there are not
express warranties (except as stated herein below) or implied
warranties (including any warranty of merchantability or fitness)
attached to the sale or use of this product.
In lieu of all other express warranties or any implied warranties
MANUFACTURER EXPRESSLY WARRANTS against defects in
material and workmanship in the security device for eighteen
(18) months from the of manufacture. During the warranty
period, the manufacturer will repair or replace, at its sole option,
free of charge, any defective unit returned freight prepaid. This
warranty shall remain in full force and effect for eighteen (18)
WARRANTY
months provided that the unit: Is owned by the original pur-
chaser; was properly installed and operated; has not been
subjected to abuse or misuse; and, has not been repaired,
altered or modified outside manufacturer’s authorized facilities.
The foregoing states the buyer’s sole and exclusive remedy for
any breach of warranty or for any claim, whether sounding in
contract, tort, strict liability or negligence, based upon any defect
in this security device. Manufacturer shall in no event be
responsible for any incidental or consequential damages
incurred by the buyer.
This warranty gives you specific legal rights and you may have
additional rights which vary from state to state.