Casio XJ-M250 - Manual (Page 59)

59
z See the “Command List” for details about command names and settings.
z All commands use ASCII characters and decimal format integers.
z The projector will return a question mark (?) when it is sent a command it cannot recognize. Also,
any command that attempts to set a value that is outside the applicable allowable range will be
ignored.
z If the projector is performing a process initiated by a previously sent command, a projector key
operation, or a remote controller key operation, send of the next command must wait until the
projector completes the previous process.
Command List
z Only the following functions are supported while the projector is turned off. Do not try to send any
other command to the projector.
z Input of a valid signal must be in progress in order to use a command to turn on blank screen or
change the aspect ratio.
R: Read enabled W: Write enabled
z Power on/off: Read
z Power on: Write
z Get light time: Read
Function
Command
Name
RW Setting Range
Power On/Off: PWR RW 0: Off, 1: On
Input Switching: 0: Switches the input source to the
COMPUTER terminal and changes the
COMPUTER terminal setting to RGB.
1: Switches the input source to COMPUTER
terminal and changes the COMPUTER
terminal setting to component.
2: Switches the input source to Video.
5: Switches the input source to USB. This
setting is supported only when the
projector is equipped with a USB function
and the USB application is running.
6: Switches the input source to COMPUTER
terminal and changes the COMPUTER
terminal setting to Auto.
7: Switches the input source to HDMI.
9: Switches the input source to S-video.
SRC RW 0: RGB, 1: Component,
2: Video, 5: USB,
6: Auto (RGB/Component),
7: HDMI, 9: S-video
Blank Screen: Switches the blank screen on or off. BLK RW 0: Off, 1: On
Volume: Specifies a value to adjust the volume level. This
setting is applied to the input source signal that is
currently being projected by the projector.
VOL RW 0-30
Color Mode: Selects the color mode. PST RW 1: Graphics, 2: Theater,
3: Standard, 4: Blackboard,
5: Game
Aspect Ratio: Specifies the aspect ratio. ARZ RW 0: Normal * 1 , 1: 16:9,
2: Normal * 2 , 3: Letter Box,
4: Full, 5: True, 6: 4:3
Get Light Time: Gets the light time from the projector. LMP R 0- Unit: Hours
*1 Input source: RGB or HDMI (PC)
*2 Input source: Video, S-video, component or HDMI (DTV)
D