Interlogix 1058 Series - Manual (Page 2)

1055/58 Series
1
/ 4
" Diameter Recessed with Wire Leads
Installation Instructions
Mounting on Wood
1: Slightly overdrill a
1 /
4
" diameter hole for the contact and coat the outside of the contact
with RTV mounting compound (part number 1905); press into hole.
2: Drill a 1 /
4
" x 1 1 /
4
" hole for the magnet ( 3 /
8
" x 1 1 /
2
" for 1056 magnet) and press into hole.
3: To improve appearance or to camouflage the contact, a wood filler of the same color as the
surrounding wood can be used to cover the hole after the contact is inserted.
Mounting on Aluminum Sliding Windows and Doors
1: Attach the contact and magnet with RTV mounting compound (part number 1905) or epoxy.
NOTE: With wide gap contacts (1055W), be certain that the red end of the magnet is away from the contact.
1042606 Rev A 05/03
GE Interlogix
www.GE-Interlogix.com 2266 Second Street North
North St. Paul, MN 55109
Phone: 651-777-2690
USA & Canada: 800-777-5484 12345 SW Leveton Drive
Tualatin, OR 97062
Phone: 503-692-4052
USA & Canada: 800-547-2556
Technical Service: 800-648-7424
Faxback: 800-483-2495
Made in Taiwan
UL Specifications
Part Loop Electrical Gap Distance
Number Type Configuration (Up to)*
1055 Closed N.O. 1 / 2
"
1055W Closed N.O. 1 1 /
4
"
1058
(not CUL listed)
Closed N.O. 1 /
2
"
** European Union Specifications: 48 V AC/DC Max., 0.5 Amp
** FORM A
Voltage: 100 V AC/DC Max
Current: 0.5 A Max
Power: 7.5 W Max
* Gap specifications are nominal and may vary
±20% due to temperature. Gap specifications are for switch to
make. Break distance is approximately 1.1 to 1.5 times make.
CUL Specifications
All Contacts: 30 VDC, 50 mA max Gap Specifications: * See UL Gap Specifications
Mounting Positions
DO NOT CENTER
SWITCH OVER
MAGNET!
Perpendicular
Parallel
End-to-End
Red end if
wide gap
Red end if
wide gap
Red end if
wide gap