Interlogix UltraView IP PTZ 36X Camera User Manual - Manual (Page 59)

Chapter 6: Network setup
UltraView IP PTZ 36X Camera User Manual 55
Parameter Description
Time settings Specifies whether to use NTP to synchronize the device clock or to to do it
manually.
NTP (Network Time Protocol) is a protocol for synchronizing the clocks of
network devices, such as IP cameras and computers. Connecting network
devices to a dedicated NTP time server ensures that they are all
synchronized.
E-mail settings Specifies the e-mail address to which messages are sent when an alarm
occurs. It is not possible to send an attachment with the e-mail
To define the network parameters:
1. In the Network Parameters folder, click the Network setting subfolder to
open its screen. Enable DHCP .
Enter the values for the IP address, subnet mask, gateway, DNS server,
device port and HTTP port. From the NIC Type drop-down list, select the
required value. Enter the multicast value, if required. Click
Save to save
changes.
2. Click the PPPoE setting subfolder to open its screen and check Enable
PPPoE. Enter the user name and password. Click Save to save changes.
3. Click the DDNS setting subfolder to open its screen and check Enable
DDNS. Enter either IP server or DynDNS as protocol.
If DynDNS is selected, enter the user name and password registered to the
DynDNS web site. The domain name is that of the DynDNS web site. Click
Save to save changes
4. Click the Time setting subfolder to open its screen. Check whether you want
to synchronize time with the NTP server or to do it manually.
If using the NTP server, enter the IP address of the NTP server and the port
number. If using the manual system enter the current date and time.
Select your time zone from the drop-down list. Click Save to save changes.
5. Click the E-mail setting subfolder to open its screen. Enter the SMTP
server, SMTP port, user name and password and the e-mail sender and
receiver addresses. Click
Save to save changes.