Interlogix TVW-2101 User Manual - Manual (Page 8)

8 TruVision Analog Wedge Camera
5. Using the the adjusting tool, loosen the adjusting screw to adjust the pan
angle (±30 °), the tilting angle (0°~ 85°), and the rotation angle (±180°). Then
tighten the adjusting screw.
6. Configure the camera by pressing OSD button. Please see“Configuring the
wedge camera” below.
7. Install the upper cover back by tightening the fasten screws.
Configuring the wedge camera
Press the OSD button on the camera to control the OSD menu. Push the button
up, down, left and right to move between the different menu options. Press the
OSD control button to select an option.
The Setup menu provides access to the camera configuration options as
following. See “OSD Menu Tree” on page 12.
Exposure
Move the cursor to Exposure and press OK to enter the exposure parameters
menu, as shown below.