beautypg.com

Cub Cadet 5254 User Manual

Page 39

background image

39

• Run the engine until it begins to stall. Use the

choke to keep the engine running until all fuel
in the carburetor has been exhausted.

• Place a small container or rag beneath the

carburetor bowl drain and loosen the drain
screw to completely drain the fuel from the
carburetor. See Figure 51.

Figure 51

3.

Clean the engine and the entire tractor
thoroughly.

4.

Drain and flush the cooling system. Refill with a
minimum 50/50 antifreeze and water coolant
solution. Use a higher percentage of antifreeze
if the tractor will be subjected to temperatures
below minus 30° F.

5.

Fully charge the battery, then disconnect the
negative cable at the battery to prevent possi-
ble discharge. Recharge the battery periodically
when in storage.

NOTE: Remove the battery if exposed to prolonged
periods of sub-freezing temperatures. Store in a
cool, dry location where temperatures are above
freezing.

6.

Lubricate all lubrication points.

7.

Jack up and block the tractor to remove the
weight from the tires if stored for a long period.
If not blocked up, reinflate the tires regularly.

NOTE: We do not recommend the use of a
pressure washer or garden hose to clean your
tractor. They may cause damage to electrical
components; spindles; pulleys; bearings; or the
engine. The use of water will result in shortened life
and reduce serviceability
.

REMOVING THE TRACTOR FROM STORAGE

Check the engine oil and coolant levels.

Fully charge the battery and inflate the tires to
the recommended pressure.

Start the engine and allow to idle for a few
minutes to ensure engine is operating properly.

Drive the tractor without a load to make certain
all the tractor systems are functioning properly.

CARBURETOR

CARBURETOR

BOWL DRAIN

DRAIN

SCREW

BOWL

FRONT OF ENGINE

LEFT VALVE

COVER