Programming, To add or reprogram a hand-held remote control, To erase all codes from motor unitmemory – Chamberlain 3595S User Manual
Page 29: Button remotes
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON
USING THE SMART CONTROL PANEL™
29
PROGRAMMING
*3-Button Remotes
If provided with your garage door opener, the large button
is factory programmed to
operate it. Additional
buttons on any
Security
✚
®
3-Button
remote or compact remote
can be programmed to
operate other
Security
✚
®
garage door openers.
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, first
erase all codes:
Press and hold the “learn” button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All
previous codes are now erased. Reprogram each remote or
keyless entry you wish to use.
1. Press and release the “learn” button
on the motor unit. The learn indicator
light will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote
*
that
you wish to operate your garage door.
3. Release the button when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
®
remote controls.
NOTICE: If this Security✚
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
LOCK
LIGHT
KG
1
3
9
7
5
KG
1
3
9
7
5
1. Press the Prog
Smart Control Panel™.
2. Press the Prog
to confirm Learn Mode.
3. Press the button on the hand-held
remote that you wish to operate your
garage door.
4. When the motor unit lights blink, it has
learned the code. If light bulbs are not
installed, two clicks will be heard.
LOC
K
LIGHT
LOC
K
LIGHT