ILY Flash Duplicator USB/FlashMax/CF/SD/eUSB - Manual (Page 9)

8
5.6.1 Verify 100%: Duplicator will read through the entire target device.
This option will NOT alter or erase the data format and existing content.
5.6.2 Check USB 100%: To check quality by “0” and “1” reading/writing the flash.
Note: Existing content will be erased during the test!!!
5.6.3 Set Range: This option allows you to define the percentage of target device
which you wish to have the duplicator to verify.
5.7 Media Information
This option displays basic information of selected media, such as type of flash media,
total capacity, file format and content size.
5.8 Device Model
This option displays basic information of selected device such as USB/ eUSB/ SD/ CF.
5.9 System Information
This option displays general information of the duplicator, including controller model,
and system firmware version.
5.10 System Update
This option allows you to update the firmware of duplicator when necessary.
Obtain proper update firmware file from manufacturer
Save the un-zipped files to a flash device supported by the duplicator (
DO NOT
put the files in a folder! ).
Select option 5.6 System Update, and press ENT. The duplicator will
automatically start updating the firmware. Once completed, please turn off the
duplicator for at least 5 seconds before turning it back on again to activate the
new firmware.
TIPS:
① . DO NOT remove any target device during the Copy process, i.e. when the
Green LED is flashing. This may not only damage the target device or the
duplicator.
Some users may like to use a USB converter to copy other different types of
flash cards, such as CF, SD, or Memory stick etc. Since the quality and stability
of each USB converter in the market is very different, a poor quality USB
converter may cause the damage to the machine and also the copy quality from
the Flash card.
•
•
•