HONDA 2002 Accord Coupe - Owner's Manual - Manual (Page 64)

Canadian models only
This indicator lights when you turn
the ignition switch to ON (II) with
the headlight switch off and the
parking brake set. It should go off if
you turn on the headlights or release
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights. The left or right turn signal light
blinks when you signal a lane change
or turn. If the light does not blink or
blinks rapidly, it usually means one
of the turn signal bulbs is burned out
(see page
). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signalling.
A burned out brake light is a hazard
when drivers behind you cannot tell
you are braking. Have your brake
lights repaired right away.
The appropriate light comes on in
this display if the trunk or either
door is not closed tightly. If a brake
light does not work, the
indicator comes on when you
push the brake pedal with the
ignition switch ON (II).
All the lights in the monitor display
come on when you turn the ignition
switch ON (II). The lights go off
after the engine starts and the trunk
and both doors are closed tightly.
When you turn on the Hazard
Warning switch, both turn signal
lights blink. All turn signals on the
outside of the car should flash.
292
‘‘Daytime Running
Lights’’ Indicator Turn Signal and
Hazard Warning
Indicators Door and Brake Lamp Monitor
Indicator Lights
Instruments and Controls 61
BRAKE
LAMP
Main Menu Table of Contents