HONDA 2005 Odyssey - Owner's Manual - Manual (Page 269)

Unplug the garage door opener
motor from the house current.
Hold the end of the garage door
opener remote control 2 to 5
inches from HomeLink. Make
sure you are not blocking your
view of the red indicator in
HomeLink.
Press and hold the remote control
button and one of the HomeLink
buttons at the same time. Plug in the garage door opener
motor, then test the HomeLink
button by pushing it. If the button
does not work, repeat the
procedure to train it again. If it still
does not work, you may have a
variable or rolling code garage
door opener. See if you do by
pressing and holding the
HomeLink button you just trained.
If the red indicator blinks for 2
seconds then stays on, you have a
rolling code garage door opener.
Go to ‘‘Training with a Rolling
Code System’’ (see page
).
Repeat these steps to train the
other two HomeLink buttons to
operate any other remotely
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
When the red indicator flashes
rapidly, release both buttons.
HomeLink should have learned
the code from the remote control.
The red indicator in HomeLink
should begin flashing. It will flash
slowly at first, then rapidly.
2.
3.
1.
4.
5.
7.
6.
269
HomeLink Universal Transceiver
268
The remote control you are training
f rom may stop transmitting af ter 2
seconds. This is not enough f or
HomeLink to learn the code. Release
and press the button on the remote
control every 2 seconds until HomeLink
has learned the code.
Main Menu Table of Contents